## page was copied from DnsTemplate ##master-page:HelpTemplate <> <> == plugin output == Plugins should simply print commands on standard output, one per line, What plugin commands are supported and how to use them? {{{ Command Description A accept mail - turn off qmail-spp in this session N next - accept current SMTP command (do not execute remaining plugins for this command) O ok - like N, but omits qmail checks in MAIL and RCPT Emsg error - do not accept this SMTP command and immediately send msg to the client LMmsg later, mail - like E, but shows error after MAIL command LRmsg later, rcpt - like E, but shows error after RCPT command LDmsg later, data - like E, but shows error after DATA command Rmsg reject mail - send msg to the client and drop connection D drop connection immediately, without printing anything Svar=value set environmental variable var to value Uvar unset var variable Hcontent header - add header content (eg. X-Spam-Flag: YES) Cfoo@bar.com change last address provided by the client to foo@bar.com (MAIL FROM or RCPT TO address) Pmsg print - send msg to the client }}} Plugins should simply print commands on standard output, one per line, eg. RCPT plugin which prints: to standard output: {{{ Cspam@myhost.com HX-Spam-Flag: YES Sspam=1 A }}} to standard error: {{{ redirected spam from <$SMTPMAILFROM> }}} will {{{ change last RCPT TO address (redirect) to spam@myhost.com add X-Spam-Flag: YES header set $spam to "1" accept mail (turn off qmail-spp for this session) log 'redirected spam from ' message (where is envelope sender address) }}} Notes {{{ each plugin command must end with a new line valid SMTP response codes are not added automatically to messages generated by plugins A, N, O, E, R and D should be used as the last command }}} == history == {{{ }}} ---- CategoryDns CategoryWatch CategoryTemplate